Vici 150 Dynacalibrator Bedienungsanleitung

Valco Instruments Co. Inc.dyna150.indd Rev 9/13VICI MetronicsDynacalibrator® Model 150Instruction ManualIntroductionUnpacking ...

82. Click “Cancel”. Since no modem is involved, this information is not necessary. The following screen will appear:3. Click “OK”, which reveals

96. Select the appropriate COM port and click “OK” to bring up this screen:7. Set the port parameters as indicated above, and click “OK”.8. Now we

109. On the Dyna150 Properties screen (above), click “Settings” to bring up the screen below. Click “Settings”Click “ASCII Setup...”Serial Port Commu

1110. Click “ASCII Setup” and set the parameters as indicated below. Click “OK”.11. When the screen returns to Dyna150 HyperTerminal (page 9, bottom

12CalculationsConcentration of the permeant compound in the span outlet stream is inversely proportional to the carrier flow rate through the chamber.

13Shutdown1. Open the permeation chamber according to the instructions in the section called “Installing the Permeation Device(s)” on page 5.2. Rem

14WarrantyThis Limited Warranty gives the Buyer specific legal rights, and a Buyer may also have other rights that vary from state to state. For a per

This page is intentionally left blank for printing purposes

1   

2

3InstallationConnections (refer to Figures 1 and 2)1. Plug the power cable from the main power connector on the rear panel of the calibrator to a 110

4Figure 2: Dynacalibrator Model 150 front and rear panelsInstallation PNLLight on Light off Light flashingFront panel control enabledFront panel con-

5Setting the Chamber Temperature ManuallyTo read the current set point: press and hold the button. To read the chassis environment temperature: pr

6Installing the Permeation Device(s)1. Turn off the power switch.2. With the tool provided, rotate the panel lock screw 90° counterclockwise.3. Gen

7Serial Port CommunicationThe Dynacalibrator Model 150 can be monitored and controlled remotely by means of a serial port connection and a terminal em